Cisco Sx350 Cli Manual page 71

ACL Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
Command Mode
Global Configuration mode
User Guidelines
After adding the name of a time range with this command, use the
periodic commands to actually configure the time-range. Multiple periodic
commands are allowed in a time range. Only one absolute command is allowed.
If a time-range command has both absolute and periodic values specified, then
the periodic items are evaluated only after the absolute start time is reached, and
are not evaluated again after the absolute end time is reached.
All time specifications are interpreted as local time.
To ensure that the time range entries take effect at the desired times, the software
clock should be set by the user or by SNTP. If the software clock is not set by the
user or by SNTP, the time range ACEs are not activated.
The user cannot delete a time-range that is bound to any features.
When a time range is defined, it can be used in the following commands:
•
dot1x port-control
•
power inline
•
operation time
•
permit (IP)
•
deny (IP)
•
permit (IPv6)
•
deny (IPv6)
•
permit (MAC)
•
deny (MAC)
Example
switchxxxxxx(config)# time-range http-allowed
console(config-time-range)#periodic mon 12:00 to wed 12:00
2
absolute and
70