Zigzag Stitching (With Overlap Back Tacking) - Mitsubishi Electric PLK-G-PAL Technical Manual

12.Zigzag stitching (with overlap back tacking)

[Example] The following type of sewing data will be created.
Operation details
(1)Setting the input method
Set the feed data from the home position H to the A
►
point with the procedures for broken line input, and
open the Input Method Setting screen.
Press Circle
►
Press Zigzag
►
Press Overlap Back Tacking
►
Set the zigzag details. Press
►
(2)Setting the zigzag details
The details are set on this screen.
►
(Press
amount to 3.0 and direction to "left"
The zigzag deflection width can be set in 0.1mm
(
increments between 0.2 and 19.0mm.)
(The zigzag feed amount can be set in 0.1mm
increments between 0.2 and 10.0mm.)
(Refer to the "Deflection width, feed amount and
creation direction" section given later for details.)
After inputting the details, press
►
data.
Memo To input the stitch width/length, press the STITCH WIDTH/LENGTH icon to invert the icon. After
that, input the data using the numeric icons or the up/down arrow mark icons.
.
.
.
.
, set the deflection width to 5.0, feed
Input zigzag stitching with overlap back tacking as
circle. (The zigzag deflection width will be 5.0mm, the
feed amount will be 3.0mm, the direction is left,. the
overlap back tacking mode will be carried out once, and
three overlap stitches will be made.)
(The bold section is the overlap back tacking section.)
.)
to set the
[7] - 34