Speed - Mitsubishi Electric PLK-G-PAL Technical Manual

<Continuation of [Feed method]>
TSS
Teaching speed setting for
short distance
STQ
Power setting of XY
stepping motor (gain)
FFS
Setting of feedforward
100% for XY stepping
motor
ZSL
ON/OFF of main axis
speed limit by presser foot
motion
TPH
Amount of maximum
movement of the arrow
input in the teaching mode.
TPY
Sets ON/OFF of the
amount of maximum
movement of the arrow
input in the teaching mode.
LH
Setting of length of
continuous feed sew in
maximum
FSH
Sets ON/OFF for max
speed of continuous
feeding becomes HIGH
setting.
FKT
Sets ON/OFF of diagonal
feed of the XY table

14.Speed

Function
HIGH
High speed
LOW
Low speed
MD1
Middle speed 1 [MD1]
MD2
Middle speed 2 [MD2]
(*1): The sewing speed might be limited according to the pitch, the setting of the thickness of the cloth, and the weight setting.
The speed limit has priority when speed limit is lower than set value(HIGH, MD1, MD2).
- 0 ~ 9
- 1 ~ 30
Setting feedforward of XY stepping motor control 100% or not
- OF
ON
ON/OFF of main axis speed limit by presser foot motion
- OF
ON
×0.1 1 ~ 200
mm
Sets ON/OFF of the amount of maximum movement of the arrow input in the teaching mode.
- OF
ON
×0.1 1 ~ 200
mm
Sets ON/OFF for maximum sewing speed of continuous feeding become the setting HIGH.
This setting is validated when the FED setting is S.
- OF
ON
Sets ON/OFF of method of feed, diagonal or not.
- OF
ON
Unit Setting range
Maximum
rpm
speed range
Minimum
rpm
speed range
Maximum
rpm
speed range
Maximum
rpm
speed range
Teaching speed for short distance can be set from [0 (slow)] to [9
(fast)].
Sets gain for XY stepping motor. [1(weak)] - [30(strong)]
Sets feedforward of XY stepping motor control not 100%
Sets feedforward of XY stepping motor control 100%
Invalidates main axis speed limit by presser foot motion
Validates main axis speed limit by presser foot motion
Amount of maximum movement of the arrow input in the teaching
mode.
The value of the setting TPH is invalid.
The value of the setting TPH is valid.
The maximum stitch range can be specified for continuous feed
sew.
Continuous feeding max speed not become HIGH set value.
Continuous feeding max speed become HIGH set value.
Feed in the direction of 45degree.
Feed in the direction of diagonal.
The speed of HIGH speed code can be set.
(*1)
The speed of LOW speed code can be set.
Speed for MD1 code (medium speed 1) can be set.
Speed for MD2 code (medium speed 2) can be set.
[16] - 11
Specification