Zigzag Stitching (With Overlap Back Tacking) - Mitsubishi Electric PLK-J Series Technical Manual

12. Zigzag stitching (with overlap back tacking)

[Example] The following type of sewing data will be created.
Operation details
(1) Setting the input method
►Set the feed data from the home position H to the A point
with the procedures for broken line input, and open the Input
Method Setting screen.
►Press Circle
►Press Zigzag
►Press Overlap Back Tacking
►Set the zigzag details. Press
(2) Setting the zigzag details
►The details are set on this screen.
(Press
to 3.0 and direction to "left"
(The zigzag deflection width can be set in 0.1mm increments
between 0.2 and 19.0mm.)
(The zigzag feed amount can be set in 0. 1mm increments
between 0.2 and 10.0mm.)
(Refer to the "Deflection width, feed amount and creation
direction" section given later for details.)
►After inputting the details, press
Note To input the ZIG WIDTH/ ZIG PITCH, press the ZIG WIDTH/ ZIG PITCH icon to invert the icon.
After that, input the data using the numeric icons or the up/down arrow mark icons.
.
.
.
.
, set the deflection width to 5.0, feed amount
)
Input zigzag stitching with overlap back tacking as
circle. (The zigzag deflection width will be 5.0mm,
the feed amount will be 3.0mm, the direction is left,
the overlap back tacking mode will be carried out
once, and three overlap stitches will be made.)
(The bold section is the overlap back tacking
section.)
to set the data.
[7]‐３５