Mitsubishi Electric PLK-G-PAL Technical Manual page 116

(8)Back to the standard screen
►Material step has been modified.
(The presser foot motion can be checked by the JOG icon)
(9)Check the correction
►Enter the modification mode. (Refer to P.[11]-1)
, then
►Press
.
►Press
(10)Moving to modified stitch position
►Move to designated position (A point) by
pressing
► The value of [PF:] has been [+0001.6 mm].
(11)Moving to next modified stitch position
►Move to designated position (B point) by
pressing
►The value of [PF:] has been [-0001.6 mm].
►After check, press
press to return to standard screen.
►Checking material step modification is complete.
.
.
.
to exit modification mode, then
[11] - 45