Mitsubishi Electric PLK-G-PAL Technical Manual page 138

(4)Setting the center position details
If the center point is not to be set on the stitching
►
data, use the arrow icons and move to the position to
be used as the center.
After setting the center, press
►
Memo If the desired center position is on the pattern
data, do not move using the arrow,
but just press
(5)Confirming execution of conversion
Press .
►
(6)Confirming the converted data
Quit the conversion mode. Press
►
the Saving mode screen. Press
the Standard screen after saving the data.
(When is pressed, the conversion executed
last will be undone.)
.
.
to change to
to return to
[12] - 14