Mitsubishi Electric PLK-G-PAL Technical Manual page 179

<Continuation of [Home position]>
HPC
Selection of home
returning operation after
power on
HPF
Prohibition of automatic
home returning when
clamp is raised
HPK
Home return icon setting
2HS
Setting for stop method at
Second home position
SHX
Do not use
SHY
Do not use
HPS
Setting for the home
returning operation when
the clamp rises at power
on.
NNU
Home positioning
prohibition when needle is
not the UP position
SHP
Home returning method
since the second time
returning
NUK
Setting ON/OFF for display
of needle up and X ICON
at M-001 message
NUM
Invalidity setting of
detection that needle is not
up position after turning
power on.
HPL
Setting of limit value for
home position
supplementation.
Sets valid/invalid of the home returning operation after power on.
- OF
ON
Sets prohibition of home returning when the clamp is raised.
- OF
ON
The home returning icon operation is selected.
- --
2
2L
NO
Action at a time when the machine reads second home position is selected.
- ST
SW
NS
Do not use
- OF
ON
Do not use
- OF
ON
Sets the home returning operation when the clamp rises at power on.
- OF
ON
Home return prohibition when needle is not the UP position
- OF
ON
Sets home returning method since the second time returning
- OF
ON
Sets for display of needle up and X ICON at M-001 message, when invalid of the home
positioning(NNU) function is ON and needle is not UP position.
If NNU function is [OF], this function is invalid.
- OF
ON
Sets of detecting whether needle is upper position or not after turning the power on.
- OF
ON
×0.1 0 ~ 10000
mm
The home returning operation is executed automatically when
the power is turned on.
Automatic home returning operation is prohibited at power supply
on.
Home return is executed regardless of state of the clamp.
Home returning is prohibited when the clamp is raised.
The home return operation is executed when the home reset icon
is turned ON once.
The home returning operation is executed when the home reset
icon is turned ON twice in succession. If the home reset icon is
turned ON only once, the home returning operation will not be
executed.
The power of the stepping motor is turned OFF (the XY table can
be moved by hands) when the home reset icon is turned ON
once, and when turned ON the second time, the home returning
operation is executed.
The home returning operation by the home reset icon is
prohibited.
When the machine reads second home position, machine is
stopped.
When the machine reads second home position, machine is
stopped and clamp goes up.
The sewing machine does not stop on the second home
position..
Home returning operation is executed regardless of clamp state
at power on.
Home returning operation is prohibited when the clamp is up at
power on.
When needle is deviated from the up position, the it is
automatically moved to up position and home positioning is
executed,
Home return is disabled when needle is not the UP position.
Does not use home returning sensor for XY stepping motor
Uses home returning sensor for XY stepping motor
Enable display of needle up and X ICON at M-001 message,
when NNU function is ON.
Disable display of needle up and X ICON at M-001 message,
when NNU function is ON.
It is detected whether needle is upper position or not, when first
returning home position or first sewing after turning the power on.
It is not detected whether needle is upper position or not, when
first returning home position or first sewing after turning the
power on. This detection is valid when (RU)=ON and
(NNU)=OFF. Caution that it is likely to sew the sewn product or
the clamp frame, when sewing is started. Caution that main axis
rotates, when (HPC)=OF.
Set the limit value of supplementation from original XY axis home
position.
[16] - 6