Modifying A Block 3 (Zigzag Input) - Mitsubishi Electric PLK-G-PAL Technical Manual

17.Modifying a block 3 (Zigzag input)

[Example] The section between the A point and B point in the following type of stitching data is modified to a
zigzag pattern.
Operation details
(1)Selecting block modification
Enter the modification mode.
►
Press Stitch Data Change
►
Block Modify
Press
►
(2)Selecting the input type
Press Zigzag
►
Set the deflection width, feed amount and creation
►
direction.
Set the deflection width to 5.0mm, feed amount to
3.0mm, and the creation direction to right (R).
Memo Refer to "[7] Methods of creating stitching data
(12)Zigzag stitching (with overlap back tacking)"
for details on the deflection width, feed amount
and creation direction.
Press
►
pressed, the deflection width and feed amount settings will be canceled.)
(3)Determining the block modification range (start point)
Using Jog
►
position.(A point)
Press
►
and
.
to open the next screen.
.
to set the data. (At this time, if
, , determine the start point
.
is
[11] - 32