(8)Creating the curve input
The data creation confirmation message "Create
►
breakpoint data" will appear.
Press
to return to the last point input screen.
►
Press
to start creation of the curve input data.
►
A message indicating that the data is being created
►
will appear.
(9)Completing curve input creation
Press
.
►
(10)Inputting the return/end code
Press
►
Data on feed data to the home position and the end
(
code will be created.)
Caution
return to the home position. Take care when the
needle is lowered, etc.
A prompt for home position return will appear.
►
Press
.
Caution
If the needle is not at the UP position, it may lower
once and then return to the UP position.
(9)Select a saving method.
After selecting the saving method, press
►
efer to section [5]Reading, writing and erasing data.)
(R
►Return to the standard screen.
.
The work holder will automatically
The needle will rise to the UP position.
icon.
[7] - 13