Curve Input - Mitsubishi Electric PLK-G-PAL Technical Manual

4.Curve input

Operation points
▪ Designate curve input (
▪ Up to 300 points can be input (A curve, passing through the current position and the input points, is
created.)
▪ A delimiter point can be inserted at a pointed corner to continuously input the curve.
[Example] The following type of sewing data will be created.
Operation details
(1)Inputting feed data to A point
Press
►
screen. After making the various settings on the Data
Setting Input screen, the Arrow Input screen will open.
(Refer to Page[6]-2)
Check that the code is set to FEED. If different code
►
is set, press
Press the arrow icons and move to the A point.
►
(Feed data to A point.)
(2)Setting feed data to A point
The movement amount can be confirmed.
►
Press
►
(Data on feed data to point A will be created.)
To change the stitching type to "CURVE INPUT",
►
press the input method setting icon.
(In this case, the
(3)Designating curve input
Press
►
Press
►
The system will return to the arrow input screen.
►
)
and on the Standard
and set the code to FEED.
to set the data.
icon.)
.
and set the data.
A delimiter is set at the C point.
[Memo] Set the stitch length between 0.1 to 10.0mm.
[7] - 11