Mitsubishi Electric PLK-G-PAL Technical Manual page 56

(2)Setting the back tacking details
The details are set on this screen.
►
(The details set here are,
(start/end back tacking),
start mode
end mode
Press to determine these set values.
►
The system will return to the input method setting
►
screen.
Press to determine the set values.
►
The system will return to the arrow input screen.
►
Determine the B point with the linear input procedures, and create a linear line.
►
After creating the linear line, press
►
(3)Confirming the data
The start/end back tacking data for the linear line has
►
been created.
Memo Regarding back tacking mode
V mode: Back tacking will be performed only
once.
N mode: Back tacking will be performed twice.
M mode: Back tacking will be performed third.
W mode: Back tacking will be performed fourth.
Memo Regarding number of stitches
Press the icon of the desired position (
After that, set data using the numeric icons or
Memo Press the back tacking data setting icon on the arrow input screen to directly display the
"detailed back tacking data setting" screen.
(N mode), three start stitches,
(N mode), three end stitches.)
.
or
.
[7] - 26
) to invert the icon.