Explanation Of Each Function Mode - Mitsubishi Electric PLK-G-PAL Technical Manual

2.Explanation of each function mode

Copy mode
The sewing data is copied "from the internal memory to an
USB memory" or "from an USB memory to the internal
memory".
[Memo] Please erase all data of the USB memory
beforehand when copying sewing data from an
internal memory.
[Memo] Sewing data will be copied in the overwriting mode.
For this reason, if the sewing data having the same
data number is in the internal memory, the new
sewing data will be overwritten on the old sewing
data.
Select the copying direction in the same way as the data reading/writing operation. (Check the picture of the
icon shown at the upper left section of the screen.)
From internal memory to USB memory
From USB memory to internal memory
Select the data you would like to copy by pressing the corresponding numeric icon (maximum 30). After that,
press to copy the data. (To select all the data, press
[Memo] Amount of datas which can be stored in the usb memory will be limited by capacity of the usb
memory and also format type specification of the usb memory. Therefore, there is some cases,
where data can not be saved even if there is enough empty space. Please check the manual of the
usb memory.
Needle DOWN angle setting
Before setting (to move to this screen), machine should be
run once, and move needle to up position by pressing
icon.
The needle position angle for the needle UP/DOWN icon is
set here.
U8 setting: Needle UP position stop setting
D8 setting: Needle DOWN position stop setting
R8 setting: Reverse run angle setting
[Memo] Refer to Program mode [Needle Position] for
details on these settings. (Page [16]-5)
Caution
Pressing the icon (
the needle.
Be careful!
) will lift or lower
.)
[13] - 2