Mitsubishi Electric PLK-G-PAL Technical Manual page 49

(4)Setting B point to K point
Press the arrow mark icon to move to point B.
►
Memo The distance between the points must be within
20mm.
Press to determine point B.
►
Press the arrow mark icon to move to point C.
►
Press to determine point C.
►
The Arrow Input screen will reappear, so press the
►
arrow icons and move to the D point to K point in the
same manner.
Press .
►
(5)Inputting the return/end code
Press
►
Data on feed data to the home position and the end
(
code will be created.)
Caution
return to the home position. Take care when the
needle is lowered, etc.
A prompt for home position return will appear.
►
Press .
Caution
If the needle is not at the UP position, it may lower
once and then return to the UP position.
(6)Select a saving method.
After selecting the saving method, press
►
efer to section [5]Reading, writing and erasing data.)
(R
►Return to the standard screen.
(7)Confirming the data
Confirm the data. Press the jog icons (
►
so the sewing machine movement can be confirmed.
(Even if the data input has not been completed, if the
data input last has been set, the movement can be
confirmed in the same manner.)
If the data must be modified, refer to section [11]
►
Modification mode Modifying the stitching data.
.
The work holder will automatically
The needle will rise to the UP position.
icon.
)
[7] - 19