Mitsubishi Electric PLK-G-PAL Technical Manual page 77

(4)Confirming with the Standard screen
The stitching start position has been modified.
►
(*1)
Memo Please note that there is a characteristic explained as follows about " Modifying the stitching
start position " of the data with the back tacking.
The data of the figure below is the straight line data which puts the start/end back tacking of V
mode. (A fat part is back tacking).
In this case, is sewn in order of A→B→C→D.
Therefore, the actual stitch starting position is "A point." (Starting location of the data origination
(input) is "B point."
Please specify whether to correct the B point because " Starting location (B) at the data input "
after work holder automatically moves to "Actual stitch starting position (A)" when enters to "
Modifying the stitching start position "
A
B
[11] - 6
D C