Mitsubishi Electric PLK-G-PAL Technical Manual page 58

Memo Overlap mode
Memo Number of overlap stitches
This is the number of stitches at the overlapped section. (Set a value between 0 and 99.)
Memo If the distance between the broken line start point and the end point is 0.5 mm or more, the
overlap back tacking data will not be created.(If the distance between the broken line start point and
the end point is less than 0.5, the pattern will be regarded as the "closed pattern", and the same
coordinate value will be automatically set for both the start point and end point.)
in the overlap mode indicate the number of overlapped sections.
[7] - 28