Reading, Writing And Erasing Data; Usb - Mitsubishi Electric PLK-G-PAL Technical Manual

[5] Reading, writing and erasing data

1. USB

To perform actions such as storing (reading/writing) sewing data on a device other than the internal memory
or reinstalling the system, a USB device is used. The device is connected to the USB connector on the front
side of the control box.
When using a USB device, be sure to fully insert the device into the USB connector. (Refer to the figure
below.)
Front panel
[Caution]
■ Connect the USB device during use only. After use, remove and store the device in an appropriate
location. When USB device is not connected, insert protection cap to the USB connector.
(Protection cap must be inserted correctly according to the shape of the USB connector)
■ Sewing cannot be performed with the USB device inserted.
■ Do not insert the USB device during sewing.
■ Be careful that nothing bumps into the inserted USB device.
Conditions of Application
▪ USB1.1 or USB2.0 compatible USB memory and USB floppy disk drive (Note, however, formatting cannot
be performed with a floppy disk drive connected to the machine.)
▪ Required power supply: USB compatible, 500mA or less
Note The write-protector might not be able to recognized according to the kind of USB device.
Please make sure to release the write-protection before writing data to the USB memory.
Inapplicable Devices ■Never connect the following devices.
▪ USB device requiring an external power supply (including Computer devices)
▪ USB hard disk drive, keyboard, mouse
▪ USB memory with fingerprint authentication function or with security function
▪ USB memory with hub function
▪ Media reader
▪ USB device without data storage function
straightforward
Certainly
(Doing so causes malfunctions.)
[5] - 1
USB memory