Mitsubishi Electric PLK-G-PAL Technical Manual page 47

(7)Inputting the return/end code
Press
►
Data on feed data to the home position and the end
(
code will be created.)
Caution
automatically return to the home position. Take
care when the needle is lowered, etc.
A prompt for home position return will appear.
►
Press .
Caution
If the needle is not at the UP position, it may lower
once and then return to the UP position.
(8)Select a saving method.
After selecting the saving method, press
►
efer to section [5]Reading, writing and erasing data.)
(R
►Return to the standard screen.
(9)Confirming the data
Confirm the data. Press the jog icons (
►
so the sewing machine movement can be confirmed.
(Even if the data input has not been completed, if the
data input last has been set, the movement can be
confirmed in the same manner.)
If the data must be modified, refer to section [11]
►
Modification mode Modifying the stitching data.
Memo
If the distance between the broken line start point and the end point is less than 0.5 mm, the
pattern will be regarded as the "closed pattern", and the same coordinate value will be
automatically set for both the start point and end point.
.
The work holder will
The needle will rise to the UP position.
icon.
)
[7] - 17