Mitsubishi Electric PLK-G-PAL Technical Manual page 52

(2)Code selection on code selection screen
Press
►
decides to pushing.
►
(The BAT code is made.)
Returns to the arrow input screen.
►
(3)Arrow input screen
Does not become SEW (Sewing) input mode and it is
►
FEED input mood after input the "BAT" code.
Input the feed data to the next B point.
►
Input the "BAT" code and the feed data from H point to
►
A point repeating.
(4)The pattern data input before return end
It is not input the "BAT" code before the last of return
►
end but the sewing data is input. Inputs here only by 1
stitch of the straight line.
Memo The purpose of inputting the sewing data at the
end is to put the thread trimmer (TRIM) code by
the automatic operation when the return end is
input. The thread trimmer(TRIM) code cannot be
input after the sewing data.
(5)Input the return end and the data completion
The return end is input and it is completion.
►
.
[7] - 22