Deflection width, feed amount and creation direction
Travel direction
left side
(3)Setting the back tacking details
After returning to the Input Method Setting screen,
►
press the back Tacking Details Setting icon
(4)Setting the overlap back tacking details
The details are set on this screen.
►
(The details set here are,
overlap mode,
After inputting the details, press
►
data.
The system will return to the input method setting
►
screen.
Press
to determine the set values.
►
The system will return to the input method setting
►
screen.
While following the circle data entry procedure, determine points B and C to create the circle data.
►
After creating the circle data, press
►
Deflection
width
Travel direction
center
Starts from left side
,
three overlap stitches.)
to set the
[7] - 35
Feed amount
Travel direction
center
Starts from right side
.
.
Travel direction
right side