Related Manuals for Mitsubishi Electric PLK-G3040R
Summary of Contents for Mitsubishi Electric PLK-G3040R
- Page 1 INDUSTRIAL SEWING MACHINE MODEL PLK-G3040R TECHNICAL MANUAL SEWING MACHINE HEAD BASIC A180E688P02...
- Page 2 FOR SAFE USE Before the installation, operation, and inspection for this product, read the “FOR SAFE USE” and the technical manuals carefully. Also read the other technical manuals, “Control Unit” and “Operation Panel” describing some instructions, which are not in this manual, and use the sewing machine properly. SAFETY INDICATIONS Indicates that incorrect handling may cause hazardous conditions, resulting DANGER...
- Page 3 SAFETY PRECAUTIONS DANGER To prevent from receiving an electric shock, always turn off a power switch and unplug power supply when opening a control box, and then open after ten minutes passes. CAUTION USAGE ENVIRONMENT Please do not operate the sewing machine under the following conditions. (1) In the ambient temperature of 35 degrees (95°F) or more than 35 degrees, or the ambient temperature of 5 degrees or less than 5 degrees (41°F).
- Page 4 SEWING (1) Please make sure to turn the power switch off before installing or replacing needles. (2) Please pay attention for the fingers not to be injured by the needle point. (3) Please make sure to turn power switch off before lubricating. (4) Please pay attention that oil does not get on your skin or in your eyes as it may cause an inflammation.
-
Page 5: Table Of Contents
CONTENTS 1. STRUCTURE OF THE SEWING MACHINE··································· 2. INSTALLATION······································································· 2-1. Securing the Sewing Machine Table························································ 2-2. Connection of the air tube····································································· 2-3. Installation of the foot switch, and connection of the control cables ················ 2-4. Installation of the thread stand································································ 3. -
Page 6: Structure Of The Sewing Machine
1. STRUCTURE OF THE SEWING MACHINE PLK-G3040R electronic pattern sewing machine consists of the following main parts. Detector Cotton stand Manual pulley Bobbin winder X･Y table Halt switch cover Presser foot regulating screw Power switch Presser foot Table Presser plate... -
Page 7: Installation
2. INSTALLATION CAUTION (1) Please have some specialists, who have enough experience for the sewing machine installations, install the sewing machine. (2) Please have a Qualified Electrician perform necessary electric wiring. (3) Please do not operate until the sewing machine is repaired when any damage or fault is found on the sewing machine at the installation. -
Page 8: Connection Of The Air Tube
2-2. Connection of Air Tube (1) Connect the attached tube between the joint E of air pressure control unit (see the lower fig.) and the compressor. (2) Turn the residual pressure exhaust valve lever to right. Compressed air is fed from IN to OUT and supplied to the air cylinder through a solenoid valve. -
Page 9: Installation Of The Foot Switch, And Connection Of The Control Cables
2-3. Installation of the foot switch, and connection of the control cables Connect the foot switch to the connector CON H. The foot switch is enclosed in the accessory box. Control cable to connect to already be connected as shown on the figure below. CON A: Operation panel CON A CON B... -
Page 10: Lubrication
3. LUBRICATION CAUTION (1) Please make sure to turn power switch off before lubricating. (2) Please pay attention that oil does not get on your skin or in your eyes as it may cause an inflammation. (3) Please make sure to keep oil out of the reach of children who may drink oil by mistake. (4) Please make sure to lubricate when operating for the first time after the installation. - Page 11 MEMO From the library of Superior Sewing Machine & Supply LLC - www.supsew.com...
- Page 12 Printed in Japan From the library of Superior Sewing Machine & Supply LLC - www.supsew.com...