Mitsubishi Electric PLK-G-PAL Technical Manual page 156

■ Reading combination data
(1) Enter the combination function to press the key
on the function mode screen.
Note When the combination function has already been set,
execute reading after releasing combination data.
(Please refer the item of Releasing combination data.)
(2) Press the key
(3) Select the combination data for the purpose intended after
changing into the function screen for reading combination
data.
The screen can be changed into the individual type such as
combination and
(Refer to the item Page [5]-2 which shows the way of
changing the internal memory in the USB memory.)
(4) Press the key
Note The sewing data in the USB memory is overwritten in the internal memory when you read the
combination data from the USB memory, when the same sewing data related to the combination
data exists. In this case, the message of confirmation is displayed, please operate carefully.
(5) The combination data has been read.
When pressing the key
the standard screen will be returned as the above-mentioned
procedure. (Page [13]-7)
Note If the key
combination data that has been read can be cancelled.
[*2] The imaging display of the combination data.
When the icon displayed on the read screen for the
combination data is pressed, the screen as shown on the
right figure will be displayed to confirm the formation of the
combination data, which is different from the screen which
shows the usual image of sewing data.
to read.
docking.
after selection.
to do the sewing operation,
is pressed at this screen, the
[13] - 10
If pressing the button, the
image of the combination data
is displayed. [*2]