9.Back tacking (overlap back tacking)
[Example] The following type of sewing data will be created.
Operation details
(1)Setting the input method
Set the feed data from the home position to the A
►
point with the procedures for broken line input, and
open the Input Method Setting screen.
Press broken Line Input
►
Press Overlap back tacking
►
Press the back tacking details setting icon
►
(2)Setting the back tacking details
The details are set on this screen.
►
(The details set here are,
(overlap back tacking),
overlap mode
Press
►
The system will return to the input method setting
►
screen.
Press
►
The system will return to the arrow input screen.
►
Determine the B, C, D and A points with the broken line procedures, and create the broken line data. (A
►
broken line having overlap back tacking will be created.)
After creating the broken line data,input
►
(3)Confirming the data
The overlap back tacking will be created with the
►
rectangle made with broken lines.
Input a rectangle as a broken line, and then insert overlap back
tacking at the end. (The overlap mode is entered once; three
overlap stitches are made.) (The bold section is the overlap back
tacking section.)
Memo It is a shutting figure in the figure made in [Broken line],
.
.
, three overlap stitches.)
to determine these set values.
to determine the set values.
[Circle], [Curve] to be able to do multiple back tacking. That
is, it is not possible to do by combining "Straight line" in the
plural in the enclosed figure. Moreover, it is not possible to
do by plural combining "Straight line" and "Curve" also even
in the enclosed figure. The multiple back tacking can be
made only by 1 place per 1 "Sewing" data origination.
.
.
[7] - 27