Names Of Each Part, Wiring And Grounding - Mitsubishi Electric PLK-J-CU-20S Technical Manual

[4] Names of each part, wiring and grounding

1.Front side
2.Back side
CON F Power supply
(Connect to power switch box)
CON G Operation panel
CON M Main servo encoder
(Connect to spindle servo motor)
CON J I/F board signal
（Connect to I/F board (MIF)）
CON P XY axis encoder
(Connect to XY axis stepping motor)
CON Q PF axis encoder
(Connect to PF axis stepping motor)
CON L Foot switch
Caution: Be sure to connect all connectors before turning ON the power. Connect each connector fully to ensure
sufficient contact. Refer to "section [13]."
Power
LED (green)
Heat sink
Front panel
CON A
"Connect to I/F board (MIF)
CON B
(Connect to spindle servo motor)
CON H
（Connect to PC）
CON K
CON D
(Connect to sewing machine head stepping
motor)
CON E
(Connect to sewing machine head PF axis
stepping motor)
[4] ‐ 1
Warning
LED (red)
Cover installation screw
(M4 screw)
Cover
Rating plate
I/F board power
"
Main servo motor
general purpose port
universal serial communication port
XY axis stepping motor
PF axis stepping motor