Preparing The Thread Guide Assembly - Brother 884-T23 Operation Manual

d Adjust the angle of the operation panel.
Loosen the 2 thumb screws behind the operation panel,
adjust the operation panel to an easy-to-view angle, and
then tighten the thumb screws.
(Side view)
1 Thumb screws

Preparing the thread guide assembly

a Using the included Phillips screwdriver, loosen the two
screws on the left side of the thread guide assembly
support so that the thread guide assembly can be
raised.
1 Remove the screw.
2 Turn the screw three or four times to loosen it.
b
(Top view)
c
Raise thread guide into position and tighten screw 2
on the left. Insert screw 1 into right side of the thread
guide assembly support and tighten.
1 Insert screw and tighten.
2 Tighten screw.
Using the Phillips screwdriver, loosen the screws on
the left and right sides of the thread guide assembly
and lift up the thread guide so that it is level.
1 Loosen screws.
GETTING READY
1
19