Installing Infrared Remote Focus Unit - ETC Expression 2.0 User Manual

Chapter 2 Installation

Installing Infrared Remote Focus Unit

The Infrared Remote Focus Unit (IRFU) allows you to set channel levels,
check dimmers, or run cues from remote locations in your studio or
theatre. The IRFU consists of two components; a receiver and a trans-
mitter. The receiver is connected to the console with a standard multi-
conductor cable. The transmitter is a hand-held, wireless unit that sends
infrared control signals to the receiving unit. To enable the IRFU in
Expression, ETC must modify the console at the factory.
To install the infrared remote control unit, follow these steps:
1. Verify that the receiver unit is properly connected to the console and
that battery in transmitter is good. (See infrared remote documenta-
tion for correct connection procedure.)
2. Press [Set Up}.
3. Select 6, System settings, and press [Enter].
4. Select 15, Enable/disable infrared control, and press [Enter].
5. Enter 0 to enable infrared controller, and press [Enter].
6. Press any key on the transmitter unit to turn power on. (Transmitter
power automatically shuts off three minutes after last key press.)
Infrared Remote Focus Unit pinout
Console connector
DIN 5-pin female
Pinout
1 Ground
2 PPM data
3 +12V
4 WSI data
5 Charge current
2 - 19