Setting Default Full Level; Setting Default Up And Down Fade Times - ETC Expression 2.0 User Manual

3 - 14

Setting default full level

The default full setting is the level Expression enters for selected
channels when you press [Full] . [Full] is set originally at 100 percent, and
is reset to 100 percent after a diagnostic system clear.
When you set the default full level below 100 percent, you can still set
channels above the [Full] level setting by using [At], [+], [-], or the fader
wheel . To set [Full] at a level other than 100 percent, follow these steps:
1. Press [Set Up] .
2. Select 6, System Settings, and press [Enter].
3. Select 1, Default Full Level, and press [Enter].
4. Either enter a two-digit intensity level, or press [Full] to set level at
100 percent.
Note: When you set dimmer levels on the softpatch screen, [Full] enters
100 percent regardless of the default full level setting.

Setting default up and down fade times

Expression automatically enters default up and down fade times unless
you specifically change them . A diagnostic system clear resets the
defaults to five seconds . To customize default fade times, follow these
steps:
1. Press [Set Up].
2. Select 6, System Settings, and press [Enter].
3. Select 2, Default Up/Down Times, and press [Enter].
4. Enter upfade time in minutes and seconds or as a fraction of a
second in decimal format, then press [enter] . Fade times can be
from .1 second to 99:59 minutes .
5. Enter downfade time in minutes and seconds or as a fraction of a
second in decimal format, then press [Enter] . Fade times can be any
length of time from .1 second to 99:59 minutes .
Expression 2.0