Installing Designer's Worksheet - ETC Expression 2.0 User Manual

Chapter 2 Installation

Installing Designer's Worksheet

Designer's Worksheet is one of the remote units available for use with
Expression. Refer to Kurta digitizer tablet documentation if you need
more information . Designer's Worksheet operation instructions begin on
page 7 - 5.
Follow these steps to install your Designer's Worksheet:
1. Insert the 6-pin XLR connector of the Designer's Worksheet cable
assembly into Expression 's connector labeled DWS/RFU.
2. Insert the plug end of the pointing device (pen or stylus) in the
worksheet connector labeled Pen/Cursor .
3. Attach the pen holder to the upper left or right hand corner of the
worksheet by removing the protective paper from the base and
pressing the adhesive to the tablet.
4. Place one printed template sheet under the clear plastic flap on the
digitizer.
5. Set the voltage selection switch to match your electrical outlet . In
the US, set the voltage switch to 110 .
6. Insert the power cord into the back of the worksheet and into a
grounded 120V AC outlet .
Note: Additional pads of Designer's Worksheet templates are available
from your dealer or ETC.
2 - 13