Reading A Show From Disk - ETC Expression 2.0 User Manual

6 - 18

Reading a show from disk

When you read a show from a disk and load it into memory, the new
show overwrites the current show in the board . Therefore, if you want
to keep the current show, follow the instructions on the previous page
to record current show before you read a new show from disk.
When using the read option, any fades being executed are interrupted
during the read operation; fades resume when read is complete . To read
a show from disk into memory follow these steps:
1. Insert disk in disk drive.
2. Press [Set Up] .
3. Select 2, Read show from disk, and press [Enter] . Expression
displays the screen illustrated below:
If either show one or two is currently recorded on disk, the screen
displays the message, Recorded, or the date recorded if you have
the Real Time Clock option . If no show is recorded on disk, Expres-
sion displays the message, Not recorded.
4. Select either show one or two, and press [Enter] . The show you
enter will overwrite the current show in memory.
Or, press [Clear] to cancel the operation.
Note: See page 4 - 38 for information about submaster pages when
reading a new show into console.
We recommend that you verify the show immediately after reading it to
ensure that is was read without errors. See page 6 - 19 for instructions.
Expression 2.0