Selecting Fader Operating Mode; Manual Control Of Linked Cues - ETC Expression 2.0 User Manual

Chapter 4 Learning the basics

Selecting fader operating mode

Follow these steps to select the desired fader mode:
1. Press [Setup].
2. Select 6, System Settings Menu, and press [Enter].
3. Select 6, Level/Proportional Rate Override, and press [Enter].
4. Press [0] to select level override mode, or press [1] to select propor-
tional rate override mode.

Manual control of linked cues

When you play back linked cues, the left fader in each fader pair controls
intensity levels; the right fader controls the playback rate . When you
begin a linked cue sequence with the right fader at 10, Expression plays
it back at the recorded rate. The LED strip on the right fader indicates
that playback is at recorded rate by holding at 5 . To take manual control
of the playback rate, move the fader down to 5, then move it up or down
to adjust rate. Moving the fader control to 10 makes playback instanta-
neous; moving it to 0 stops playback.
If right fader is set at anything other than 10 when you start the
autoload, the linked cues or effects playback at the rate set on the fader.
4 - 31