Installing Remote Focus Unit - ETC Expression 2.0 User Manual

2 - 16

Installing Remote Focus Unit

The Remote Focus Unit (RFU) allows you to set channels levels, check
dimmers or run cues from remote locations.
To install Remote Focus Unit, follow these steps:
1. Verify that RFU power switch is turned Off.
2. Insert the RFU cable into the connector on the back of the console
labeled, RFU/DWS.
3. Turn RFU power switch to On . Expression displays the message,
RFU On, when RFU is properly installed and turned on.
RFU connector and pinout
Console connector
XLR 6-pin female
Pinout
1 Data (+) (to RFU)
2 Data (-)
3 Data (+) (from RFU)
4 Data (-)
5 Common (AC ground)
6 +12 VDC (fused, 2 A)
Expression 2.0