Playing Back Autoloads - ETC Expression 2.0 User Manual

5 - 46
5. To modify playback rate, press [Time] . Enter a number between zero
and 100 to indicate playback rate: zero stops the sequence, 50 plays
it back at the recorded rate, and 100 flashes through cues or steps
instantaneously.
6. Enter cue number you want to play from CD fader, and press
[Enter].
7. Repeat steps four and five, if necessary, for second cue.

Playing back autoloads

To playback autoloads, press [Autoload], and enter number of the
autoload you want to playback . Then press either [Go] key .
When you playback autoloads, the left fader in each fader pair controls
intensity levels . The right fader controls the playback rate . When you
begin an autoload with the right fader at 10, Expression plays it back at
the recorded rate; the LED strip indicates 50 percent on the right fader .
To take manual control of the playback rate, move the fader to 50
percent . Then move the fader up or down to adjust rate; 10 is instanta-
neous playback through steps or cues, and 0 stops playback.
If right fader is set at any position other than 10 when you start the
autoload, the linked cues or effects playback at the rate set on the fader.
Expression 2.0