ETC Expression 2.0 User Manual page 209

Chapter 8 Reference
Recording submaster using bump switches
You may also use bump switches to indicate the submaster in which
you want to record a current look . To record a pile-on submaster using a
bump switch, follow these steps:
1. In either Stage or Blind mode, create a look on the screen.
2. Press [Rec] to indicate that you want to save the look.
3. Press the bump switch of the submaster in which you want to
record the look . A lit LED indicates that the submaster is success-
fully recorded.
To record an inhibitive submaster, follow these steps:
1. In either Stage or Blind mode, select channels you want to include in
the submaster.
2. Press [Rec] [Sub] [-] to indicate that you want to record an inhibitive
submaster.
3. Press the submaster bump switch where you want to record the
inhibitive submaster.
8 - 9