Corner Behavior: G450, G451 - Siemens SINUMERIK 802D sl Programming And Operating Manual

Programming example
N10 T... F...
N15 X... Z...
N20 G1 G42 X... Z...
N30 X... Z... ;
3.6.4

Corner behavior: G450, G451

Functionality
Using the functions G450 and G451, you can set the behavior for non-continuous transition
from one contour element to another contour element (corner behavior) when G41/G42 is
active.
Internal and external corners are detected by the control system automatically. For internal
corners, the intersection of the equidistant paths is always approached.
Programming
G450
G451
I
Figure 3-31 Corner behavior at an external corner
Figure 3-32
Grinding
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
; P0 - starting point
; Selection right of contour, P1
; Starting contour, circle or straight line
;Transition circle
;Point of intersection
S
Corner behavior at an internal corner
3.6 Tool and tool offset
I
S
Programming
3-67