Siemens SINUMERIK 802D sl Programming And Operating Manual page 138

Cycles
4.4 Zyklenunterstützung im Programmeditor
To add a cycle call to the program, carry out the following steps one after the other:
● From the horizontal softkey bar, selection bars for the individual cycles can be changed
● The cycle selection is carried out using the vertical softkey bar until the appropriate input
● Number values can be directly entered. Entered values are verified for proper range.
● Some parameters that may have only a few values are selected using the toggle key.
● Press <OK> to complete your input (or <Abort> in case of error).
Recompiling
Recompiling of program codes serves to make modifications to an existing program using
the cycle support.
Position the cursor on the line to be modified and select the <Recompile> softkey. This will
reopen the corresponding input screen from which the program piece has been created, and
you can modify and accept the values.
4-8
using the <Grinding cycles> softkey.
screenform with the help display appears on the screen.
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Grinding