Table 5-2 Description Of The Parameters In The Mda Working Window - Siemens SINUMERIK 802D sl Programming And Operating Manual

Operating areas and operating modes
5.2 Machine operating area
Parameter
Table 5-2
Parameter
MCS
X
Z
+X
-Z
Position
mm
Distance-to-
go
G function
Spindle S
r.p.m.
Feedrate F
Tool
Editing
window
Note
If a second spindle is integrated into the system, the workspindle will be displayed using a
smaller font. The window will always display the data of only one spindle.
The control system displays the spindle data according to the following aspects:
The master spindle is displayed:
- Idle,
- at spindle start
- with both spindles active
The workspindle is displayed:
- when starting the workspindle
The power bar applies to the spindle currently active.
Softkeys
An explanation of the horizontal softkeys is found in the JOG Section.
The G function window displays G functions whereby each G function is assigned to a group
and has a fixed position in the window.
5-8
Description of the parameters in the MDA working window
Explanation
Displays the existing axes in the MCS or WCS
If you traverse an axis in the positive (+) or negative () direction, a plus or minus sign
will appear in the relevant field.
If the axis is already in the required position, no sign is displayed.
These fields display the current position of the axes in the MCS or WCS.
This field displays the distance to go of the axes in the MCS or WCS.
Displays important G functions
Displays the actual value and the setpoint of the spindle speed
Displays the path feedrate actual value and setpoint in mm/min or mm/rev.
Displays the currently active tool with the current edge number (T..., D...).
In the "Stop" or "Reset" program state, an editing window serves to input a part pro-
gram block.
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Grinding