Table 6-1 Allocation Of Dressers - Siemens SINUMERIK 802D sl Programming And Operating Manual

Define
6.2 Create new tool
Cutting edges 7-9 are the three available dressing tools have a fixed allocation to the stan-
dard contour cutting edge.
Table 6-1
D field
D7
D8
D9
In the next step, the tool data are to be entered.
● Nominal dimensions for monitoring
● Geometry data
● Technological data
● Data for the dressers
Nominal dimensions and monitoring
This function opens in input screen into which grinding wheel nominal dimensions and moni-
toring data are entered.
Figure 6-6
Geometry data
This function is used the enter the wheel geometry for the wheel type selected.
The following wheel types are available:
● Vertical wheel without back-slopes (type 1)
6-6
Allocation of dressers
Dresser Assignment
Dresser 1 Left-hand front cutting edge
Dresser 2 Right-hand rear cutting edge
Dresser 3 Optional for wheel diameter
Grinding wheel nominal dimensions and monitoring data
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Grinding