Siemens SINUMERIK 802D sl Programming And Operating Manual page 145

Parameter
ZU_ART
BVU1
BVU2
F_PE
F_SR
F_SL
F_FSL
N_FR
MZ
KS
F_KS
Example for multiple plunge-cutting
A cylinder (diameter 200) is to be machined completely using a wheel (width 70 mm).
When grinding by reciprocating, the wheel is to be fed in from the right and grinding is to be
performed using the "Exact stop fine" motion behavior. A direct-contact vibration pick-up and
a measurement control are installed on the machine.
Additional specified values:
A_SR=0.5 mm
A_SL=0.3 mm
A_FS=0.2 mm
SLZ=0.1 mm
FSZ=0.005
N_FR=3
Grinding
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Data type Meaning
Int Infeed
-1 = only on the left
0 = on both sides
1 = only on the right
Int Dwell time at reversal point1
Int Dwell time at reversal point2
real Feedrate for reciprocating in Z
real Feedrate for roughing
real Feedrate for finishing
real Feedrate for fine-finishing
Int Number of sparking-out strokes
Int Measurement control Yes=1 / No=0
Int Direct-contact vibration pick-up yes=1 / no=0
real Feedrate for air grinding [mm/min]
4.6 Multiple plunge-cutting – CYCLE411
Roughing allowance
Finishing allowance
Fine-finishing allowance
Infeed amount for finishing
Infeed amount for fine-finishing
Number of sparking-out strokes
Cycles
4-15