Shaping/Dressing - Siemens SINUMERIK 802D sl Programming And Operating Manual

Define

6.5 Shaping/dressing

6.5 Shaping/dressing
Functionality
This function is used to shape a "raw" grinding wheel without generating an NC program.
The procedure always refers to the currently active tool.
Operation
Shaping is done in JOG mode.
The input screen is opened.
Figure 6-14
The required shaper values that are machined in dressing strokes are entered using the in-
put fields
For a new wheel (no wear), the shaper allowance is suggested by the control system. The
number of dressing strokes can be freely selected.
The automatic mode is enabled by pressing the <Start prof.> softkey.
The cycle will be started.
In the cycle, the shaper allowance is machined first and then all dressing strokes are exe-
cuted. The current state is shown in the fields. The procedure can be aborted and restarted
at any time. Values can be modified.
6-16
Shaping
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Grinding