Table 5-7 Memory Areas - Siemens SINUMERIK 802D sl Programming And Operating Manual

Figure 5-37
The baud rate is set using the toggle field. The following values are possible: 9600 / 19200 /
38400 / 57600 / 115200.
Use this softkey to activate the connection between the control system and the PC/PG. It is
waited for the call of the Programming Tool. No modifications to the settings are possible in
this status.
The softkey labeling changes to <Disconnect>.
You can cancel the transmission from the control system at any point by pressing Discon-
nect. Now it is possible again to make changes in the settings.
The active or inactive state is kept even after Power On (except power-up with the default
data). An active connection is displayed by a symbol in the status bar.
Press <RECALL> to quit the menu.
Use this function to display and change the current states of the memory areas listed in the
table
It is possible to display 16 operands at the same time.
Table 5-7
Inputs
Outputs
Flags
Times
Meters
data
Format
Grinding
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Communication settings
Memory areas
I Input byte (IBx), input word (Iwx), input double-word (IDx)
Q Output byte (Qbx), output word (Qwx), output double-word (QDx)
G Flag byte (Mx), flag word (Mw), flag double-word (MDx)
T Time (Tx)
C Counter (Cx)
V Data byte (Vbx), data word (Vwx), data double-word (VDx)
B Binary
H Hexadecimal
D Decimal
The binary representation is not possible with double words. Counters and timers
are represented decimally.
Operating areas and operating modes
5.5 System operating area
5-37