Siemens SINUMERIK 802D sl Programming And Operating Manual page 153

A_SR
A_SL
F_SR, F_SL (feedrate)
Different feedrates can be specified for the individual machining steps. They are program-
med in [mm/min].
F_SR
F_SL
TIME (sparking-out time)
After reaching the workpiece finished dimension, the tool dwells at the end position for a de-
fined time. This time is called 'sparking-out time'. It is programmed in [s].
KS (direct-contact vibration pick-up)
The KS parameter is used to specify whether a caliper is used.
0 = without direct-contact vibration pick-up
1= with direct-contact vibration pick-up
F_KS (feedrate for air grinding)
With an air grinding feedrate, the path between the starting point and the point where the
wheel comes into contact with the workpiece (with the aid of the direct-contact vibration pick-
up) is traversed.
OSW (reciprocation travel)
During shoulder plunge-cutting, this parameter can be used to activate a short-travel recipro-
cation. Starting point is the position under X_ST. It is programmed in [mm].
F_OSCILL (reciprocation speed)
The reciprocation speed is programmed in [mm/min].
Grinding
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
4.7 Shoulder plunge-cutting – CYCLE412
Roughing allowance
Finishing allowance
Feedrate for roughing
Feedrate for finishing
Cycles
4-23