Reapproach After Cancellation; Reapproach After Interruption - Siemens SINUMERIK 802D sl Programming And Operating Manual

7.6

Reapproach after cancellation

After a program cancelation (RESET), you can retract the tool from the contour in Manual
mode (JOG).
Operating sequence
Select Automatic operating mode
Opening the Block search window for loading the interruption point.
The interruption point is loaded.
The block search to the interruption point will start. An adjustment to the start position of the
interrupted block will be carried out.
Press <NC START> to continue program execution.
7.7

Reapproach after interruption

After a program interruption (<NC STOP>), you can retract the tool from the contour in man-
ual mode (JOG). The control saves the coordinates of the point of interruption. The distances
traversed are displayed.
Operating sequence
Select Automatic operating mode
Press <NC START> to continue program execution.
Caution
When reapproaching the interruption point, all axes will traverse at the same time. Make sure
that the traversing area is not obstructed.
Grinding
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Operator control (software)
7.6 Reapproach after cancellation
7-7