Siemens SINUMERIK 802D sl Programming And Operating Manual page 214

Operating areas and operating modes
5.5 System operating area
Figure 5-31
● Selecting the axis: To select the axis, use the "Axis" toggle field.
● Signal type: Following error
● Status: On - Recording is performed on this channel
The parameters for the measuring time and for the trigger type for channel 1 can be set in
the lower screen half. The remaining channels will accept this setting.
● Determining the measuring period: The measuring period in ms is entered directly into
● Selecting the trigger condition: Position the cursor on the "Trigger condition" field and se-
The <V mark ON> / <V mark OFF> or
5-32
Select signal
Controller difference
Contour deviation
Position actual value
Speed actual value
Speed setpoint
Compensation value
Parameter block
Position setpoint controller input
Speed setpoint controller input
Acceleration setpoint controller input
Speed feedforward control value
Exact stop fine signal
Exact stop coarse signal
Off - Channel is inactive
the "Measuring period" input field (6,133 ms max.).
lect the relevant condition using the toggle key.
– No trigger, i.e. the measurement starts directly after selecting the "Start" softkey;
– Positive edge;
– Negative edge
– Exact stop fine reached;
– Exact stop coarse reached
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Grinding