Software interface
2.1 Screen layout
Table 2-1
Screen item
①
②
③
④
⑤
⑥
⑦
Tip and softkey area
Figure 2-3
2-2
Explanation of the screen controls in the status area
Display
Meaning
Active operating area, active mode
Position
JOG; 1 INC, 10 INC, 100 INC, 1000 INC, VAR INC
(evaluation by increments in JOG mode)
JOG REF
MDA
AUTOMATIC
OFFSET PARAM
PROG MANAGER
SYSTEM
ALARM
Alarm and message line
In addition, the following is displayed:
1. Alarm number with alarm text, or
2. Message text
Program status
RESET
Program canceled / default status
RUN
Program running
STOP
Program stopped
Program controls in the AUTOMATIC mode
Reserved
NC messages
Selected part program (main program)
Tip and softkey area
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Grinding