Siemens SINUMERIK 802D sl Programming And Operating Manual page 162

Cycles
4.10 Reciprocating – CYCLE415
Parameter
A_SR
A_SL
A_FSL
SRZ
SLZ
FSLZ
ZU_ART
BVU1
BVU2
F_PE
FP_SL
FP_FS
F_SR
F_SL
F_FSL
N_FR
MZ
KS
F_KS
Example for reciprocating
This cycle will be used to machine the cylinder (diameter 200) completely with grinding by
reciprocating using a wheel 70 mm in width.
When grinding by reciprocating, the infeed is to be performed from the left and grinding is to
be performed using the "Exact stop fine" motion behavior.
A direct-contact vibration pick-up and a measurement control are installed on the machine.
Additional specified values:
A_SR=0.5 mm
A_SL=0.3 mm
A_FSL=0.2 mm
SRZ= 0.2 mm
SLZ=0.1 mm
FSLZ=0.005
N_FR=3
4-32
Data type Meaning
real Roughing allowance (incr.)
real Finishing allowance (incr.)
real Fine-finishing allowance (incr.)
real Infeed amount for roughing (incr.)
real Infeed amount for finishing (incr.)
real Infeed amount for fine-finishing (incr.)
Int Infeed
-1 = only on the left
0 = on both sides
1 = only on the right
Int Dwell time at reversal point1
Int Dwell time at reversal point2
real Reciprocation feedrate for roughing
real Reciprocation feedrate for finishing
real Reciprocation feedrate for fine-finishing
real Feedrate for roughing
real Feedrate for finishing
real Feedrate for fine-finishing
Int Number of sparking-out strokes
Int Measurement control Y=1 / N=0
Int Direct-contact vibration pick-up Y=1 / N=0
real Feedrate for air grinding [mm/min]
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Roughing allowance
Finishing allowance
Fine-finishing allowance
Infeed amount for roughing
Infeed amount for finishing
Infeed amount for fine-finishing
Sparking-out strokes
Grinding