Siemens SINUMERIK 802D sl Programming And Operating Manual page 121

Machine manufacturer
The following settings are defined in machine data:
● The angle between a machine axis and the oblique axis,
● The position of the zero point of the tool relative to the origin of the coordinate system
● The speed reserve held ready on the parallel axis for the compensating movement,
● The axis acceleration reserve held ready on the parallel axis for the compensating
Axis configuration
To program in the Cartesian coordinate system, it is necessary to inform the control of the
correlation between this coordinate system and the actually existing machine axes (MU,MZ):
● Assignment of names to geometry axes
● Assignment of geometry axes to channel axes
● Assignment of channel axes to machine axis numbers
● Identification of spindles
● Allocation of machine axis names.
Apart from "inclined axis active", the procedure corresponds to the procedure for normal axis
configuration.
Grinding
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
specified by the "inclined axis" function,
movement.
– general situation (inclined axis not active)
– inclined axis active
Programming
3.13 Inclined axis
3-91