Siemens SINUMERIK 802D sl Programming And Operating Manual page 232

Define
6.2 Create new tool
Figure 6-3
Confirm your input using <OK>.
Figure 6-4
A data record loaded with zero will be included in the tool list. This data block consists of 9
cutting edges (D fields). The first 6 cutting edges have a cutting edge type and are used as
cutting edge geometry points.
The tool is assigned to a grinding spindle by an entry in the "S No" field. For values ≤0, an
externally controlled grinding spindle is used, for values >0, the grinding spindles of the con-
trol system are known.
Note:
Cylindrical grinding begins for S2.
Flat grinding for S1.
The conversion is done internally, for an entered value of 1.
For standard wheels (vertical and inclined), the D numbers are associated to a fixed mean-
ing (refer to the "corrective value" figure). Based on the geometry data, this allocation is al-
ways set by default for setting up and dressing.
6-4
New tool
Tool list
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Grinding