Siemens SINUMERIK 802D sl Programming And Operating Manual page 38

Programming
3.1 Fundamental Principles of NC Programming
Address Meaning
G59 6. Settable zero offset
G53 Non-modal skipping of the settable work
offset
G153 Non-modal skipping of the settable work
offset including base frame
G60 * Exact stop
G64 Continuous-path mode
G9 Non-modal exact stop
G601 * Exact stop window, fine, with G60, G9
G602 Exact stop window, coarse, with G60, G9
G70 Inch dimension input
G71 * Metric dimension data input
G700 Inch dimension data input; also for
feedrate F
G710 Metric dimension data input; also for
feedrate F
G90 * Absolute dimension data input
G91 Incremental dimension data input
G94 * Feed F in mm/min
G95 Feedrate F in mm/spindle revolutions
G96 Constant cutting rate ON
(F in mm/rev., S in m/min)
G97 Constant cutting speed OFF
G450 * Transition circle
G451 Point of intersection
BRISK * Jerking path acceleration
SOFT Jerk-limited path acceleration
FFWOF * Feedforward control OFF
FFWON Feedforward control ON
WALIMON * Working area limitation ON
WALIMOF Working area limitation OFF
DIAMOF Radius dimensioning
DIAMON * Diameter dimensioning
G290 * SIEMENS mode
The functions marked with an asterisk (*) act when starting the program (in the default condition of the control system,
unless otherwise programmed and if the machine manufacturer has preserved the default settings for the grinding technol-
ogy).
3-8
Value assignments Information
9: Skipping of the settable work
offset
non-modal
10: Approach behavior
modally effective
11: Non-modal exact stop
non-modal
12: Exact stop window
modally effective
13: Inch / metr.dimension input
modally effective
14: Absolute / incremental di-
mension
modally effective
15: Feedrate / spindle
modally effective
18: Behavior at corners when
working with tool radius com-
pensation
modally effective
21: Acceleration profile
modally effective
24: Precontrol
modally effective
28: Working area limitation
modally effective
29: Dimension input Radius /
diameter
modally effective
47: External NC languages
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Programming
G96 S... LIMS=... F...
; applies to all axes activated
via setting data;
values set via G25, G26
Grinding