Siemens SINUMERIK 802D sl Programming And Operating Manual page 134

Cycles
4.2 Programming cycles
If you want to exclude the last transfer parameters that have to be written in a call, you can
prematurely terminate the parameter list with ")". If any parameters are to be omitted within
the list, a comma "..., ,..." must be written as a placeholder.
Note
No plausibility checks are made of parameter values with a discrete or limited value range
unless an error response has been specifically described for a cycle.
If a cycle is called the parameter list of which contains more entries than parameters defined
in the cycle, the general NC alarm 12340 "Too many parameters" is displayed and the cycle
is not executed.
Cycle call
The individual methods for writing a cycle are shown in the programming examples provided
for the individual cycles.
4-4
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Grinding