Table 5-8 Interface Parameters - Siemens SINUMERIK 802D sl Programming And Operating Manual

Operating areas and operating modes
5.5 System operating area
Interface parameters
Table 5-8
Parameter
Listing
Baud rate
Stop bits
Parity
Data bits
Overwriting
with confirmati-
on
5-44
Interface parameters
Description
RTS/CTS
The signal RTS (Request to Send) controls the Send mode of the data transfer
device.
Active: Data are to be sent.
Passive: The Send mode is only quit after all data have been transmitted.
The CTS signal indicates the readiness to transmit data as the acknowledgment
signal for RTS.
Setting the baud rate.
300 Baud
600 Baud
1,200 Baud
2,400 Baud
4,800 Baud
9,600 Baud
19,200 Baud
38,400 Baud
57,600 Baud
115,200 Baud
Number of stop bits with asynchronous transmission
Input:
1 stop bit (default setting)
2 stop bits
Parity bits are used for error detection. These are added to the coded character to
convert the number of digits set to "1" into an odd or even number.
Input:
No parity (default setting)
Even parity
Odd parity
Number of data bits with asynchronous transfer.
Input:
7 data bits
8 data bits (default)
Y: When reading in, it is checked whether the file already exists in the NC.
N: The files are overwritten without confirmation warning.
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Grinding