Select And Start Of A Part Program - Siemens SINUMERIK 802D sl Programming And Operating Manual

Use this softkey to delete a selected text (alternatively: <CTRL+X>)
Use the <Find> softkey to search for a string in the program file displayed.
Type the term you are looking for in the input line and use the <OK> softkey to start the
search.
Use <Abort> to close the dialog box without starting the search process.
Use this softkey to replace the block numbers from the current cursor position up to the pro-
gram end.
With this softkey function, parts of programs that can be added to other programs are stored.
See Section "Cycles"
For recompilation, position the cursor on the cycle calling line in the program. This function
decodes the cycle name and prepares the screenform with the relevant parameters. If there
are any parameters beyond the range of validity, the function will automatically use the de-
fault values. After closing the screenform, the original parameter block is replaced by the cor-
rected block.
Note: Only automatically generated blocks can be recompiled.
7.3

Select and start of a part program

Functionality
Before starting the program, make sure that both the control system and the machine are set
up. Observe the relevant safety notes of the machine manufacturer.
Operating sequence
Select Automatic mode by pressing the <Automatic> key on the machine control panel.
The Program Manager is opened. Use the <NC directory> (default selection) or <Customer
CF card. softkeys to enter the appropriate directories.
Grinding
Programming and Operating manual, 06/2006, 6FC5398-4CP10-0BA0
Operator control (software)
7.3 Select and start of a part program
7-3